Iridium gives you the option to bypass either the amp modeling or the IR cab processing for different use cases. However, in some setups, using a DI may help if you encounter any noise or ground loops when connecting Iridium’s outputs directly to a PA/mixer or require balanced connections. The buffered signal when both engaged or bypassed can handle sending signals over long cable runs. Iridium’s LEFT and RIGHT audio outputs are 1/4″ unbalanced buffered outputs. It is not really recommended to be placed in front of an amplifier, but if you disable the IR Cab in Cab Bypass mode, you can connect Iridium’s output(s) into the Power Amp Input/Effects Return of an amplifier to use as the preamp for your amplifier. Connecting to a PA/mixer or powered full range/flat response speakers.Iridium is an amp modeler and IR cab processor that can be used in a variety of ways. With both the amp and IR cab processing active, it is designed for: Release the footswitch and use the DRIVE knob to select the INPUT LEVEL.Press and hold the FAV footswitch while connecting power to Iridium until both LEDs start blinking.***NOTE: Never connect the speaker output from an amplifier into Iridium!!!*** If using Line Level signals, please make sure to set the INPUT LEVEL to LINE. Iridium can accept Instrument (-10dB) or Line Level (+4dB) signals up to +8dBu. Iridium has a single input that will work with MONO or STEREO TRS input signals depending on the setting of the Input Selector switch on the back of the pedal.
0 Comments
Leave a Reply. |